3G & APP

How to use iPhone App Netcamviewer to view Brickcom IP Camera?

Follow the steps below to get the video streaming on iPhone.

Scenario:


Step1. Go to the Video Configuration page and configure the stream setting as the parameters below.
Aspect Ratio as 4:3
Video codec as H.264 for stream1
Resolution as 640x480or lower
Frame Rate as 5 fps
Bitrate 512Kbps
The Video settings of 3GPP will need to be configured depends on the bandwidth of your network environment. The configuration is just for the reference.


Step2. Go to the HTTP/HTTPS Configuration page and configure the HTTP port, e.g. 2000.



Step3. Configure the Port Forwarding rule in Router. Add the port 2000 to IP Camera’s IP Address.



Step4. Connect iPhone to Internet, via 3G or Wi-Fi.



Step5. Download and install the Netcamviewer, to enable the Netcamviewer.



Step6. The main setting window in Netcamciewer.



Step7. Configure the profile with proper information.



Step8. Configure another profile with proper information.



Step9. Configure MultiView profile with proper information.



Step10. Go back to the main window and choose the profile you want to view.



Step11. Go back to the main window and choose the MultiView profile.



Note:
*Maximum to 2 channels (4 channels with charge).
*Support maximum to dual view(quad view with charge)
*Able to assign different ports for different cameras
*Support to view which fits iPhone display screen
*Able to take snapshots of your cameras on iPhone

台灣

上海